how to install transmission and motor in whirpool washer

Loosen the drive block with a hammer and pull it from the drive shaft.Lift the inner tub up and out from the machine using caution as the tub is heavy.Use a tub nut wrench and hammer to loosen and remove the tub nut by rotating counterclockwise.

Lift the agitator up and out of the washing machine and set aside.

Use a 7/16 socket to remove the agitator bolt.

Remove the fabric dispenser from the agitator and pull the agitator cap off.

Use a flathead screwdriver to release the tabs that secure the tub ring.

Pull the maintop forward, lift it up, and support it.

Remove the screws that secure the wiring and tube cover.

Have a towel and a bucket ready for any water that may spill out.

Disconnect the hot and cold water hoses from the water inlet valve.

Shut off the hot and cold water valves.

Unplug the washer from its power source.This indicates that the clutch needs replacing.If you’d like to tackle this job yourself, however, follow along closely to the following tutorial. If the clutch has gone out, sometimes you will notice a black substance on the ground underneath the washer. If the washer doesn't agitate, the problem could be many of the same things: a faulty lid switch, the coupler on the motor, a worn belt or clutch, a failed drive motor or pulley, or the transmission. The agitator is designed to move the clothes around in the water before the spin cycle. Unfortunately, the whole motor needs to be replaced if this fails. It can burn out moving in one direction while continuing to work going the other way. Drive motors are designed to move in two directions. Other possible culprits include a broken belt, a worn clutch, or a malfunctioning drive motor. Replacement is the only option when it breaks down. Another possible cause is a broken coupler, the plastic or rubber connector that joins the shaft of the motor to the transmission. Pumps, but Won't SpinĪgain, the lid switch could cause the washer to pump water, but not spin. This switch is near the door frame, inside the washing machine. This could occur with the motor running, and if it doesn't, it is likely due to a failed lid switch. It may happen that the washing machine fails to pump water in and out, as well as spin. The five most common signs of motor issues are listed below.įind your washing machine motor on Amazon. If the motor goes out, everything else will fail to function.

How to install transmission and motor in whirpool washer